- Every monday 30 min calls to discuss work break down for week → is this time fine?
- Daily 15-30 min check in calls
- Hugh will provide a user manual for the vn-100
- IMU/Gyroscope/Magnetometer
- Magnetorquer → theoretical measurements that has specs on the required voltage and power that the torquer needs in order to achieve its output actuation
- Once winding mechanism is ready, we will start testing to get better torquer output numbers
- Mounting is not finalized → hole placement needs to be defined
- Update on rxn wheel layout
- @Hugh Dawson to confirm with algorithm group on what they programmed for - sorted
- @Shreya Singh to get back latest within 2 days of chawthri’s suggestion
- @Saksham Ahuja to review motor options that joel picked + figure out connections for first rev
- all 4 rxn wheels on one end away from pcb stack
- Torque Requirements: How to Properly Size Components
- Redundancy Requirements: Redundancy Requirements
- @Hugh Dawson to talk to Azzam about the specs for the motor selection to confirm if brushless is a huge need or not
-
How will the magnetorquer interface with the OBC?
- To Kiran’s understanding, we can just send a PWM signal from the OBC to the H-Bridge on the ADCS board? - yes, sorted
- @Joel Lee to fix the blk diagram
.png)
- If not, let Kiran and/or Julia ASAP
-
How will the reaction wheels interface with the OBC?
- Depends on brushed vs brushless from what I’ve been told